←

Coat stand

W 60 × H 180 × D 60 cm

You need:

  1. 6 ×  Connector (angle)
  2. 1 ×  Wooden rod L 185 cm
  3. 1 ×  Wooden rod L 175 cm
  4. 1 ×  Wooden rod L 165 cm
  5. 1 ×  Wooden rod L 85 cm
  6. 1 ×  Wooden rod L 50 cm
  7. 1 ×  Helper
  8. 1 ×  Wrench
  9. 1 ×  Measuring tape

First read about the proper usage and watch the video:

How-to Video

1

Take the 175 cm long rod and position a clamp 39cm from one end. Position a second clamp 2cm above it. Turn the each hex nut one revolution.

2

Take the 185 cm long rod and place a clamp C 56.5 cm from one end.

3

Connect the rods by fastening the nut. The two ends of the rods should be about 56 cm apart. Pull the hex nut tight.

4

Take the 165 cm long rod and place a clamp C 29cm from one end.

5

Connect it to the other two rods.

6

Ask your helper to hold the poles while you adjust the connection if necessary in order to align the rods exactly. Afterwards tighten all the hex nuts.

7

Your coat stand may be a little different, so the following dimensions are all approximations.

8

Fix two clamps A on each side of the 50 cm long rod, approximately 19.5 cm apart, pointing in opposite directions.

9

Position a clamp C on the 175 cm long rod at a height of approximately 76.5 cm and another on the 165 cm long rod at a height of approximately 70 cm.

10

Connect the rods. Fasten one side first, then the other. Ask your helper to hold the clamps / rods.

11

Fix two clamps A on each of the 85 cm long rod, approximately 42.5 cm apart, pointing in opposite directions.

12

Position a clamp C on the 185 cm long rod at a height of approximately 79 cm and another clamp C on the 175 cm long rod at a height of approximately 39 cm.

13

Connect the rods. Fasten one side first, then the other. Ask your helper to hold the clamps / rods. Then tighten the hex nuts.

14

Make sure that all the hex nuts are fastened tight. Finished.